Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 99)

Remote Infrastructure Management System - Version 1.0 / July 2014
Chatsworth Products, Inc. (CPI) • 800-834-4969 99
3.4.24 Modbus/SNMP/BACnet Slave Units
This section provides configuration information for basic Slave unit functionality. If you’d like to configure more advanced features,
including Modbus Register Configuration, refer to Chapter 4, “Advanced Communications - Modbus, BACnet, and Telnet” on page 129.
The Modbus/SNMP Slave Unit Configuration can only be configured after the Modbus/SNMP/BACnet/Telnet Master has been set up;
see “Modbus/SNMP/BACnet/Telnet Master” on page 96. Users must tell the RIM-1000 that they are using it for Modbus communications
before users can configure the Modbus slave units.
The Slave Unit Configuration page will change depending on what type of Protocol users set it up for (i.e., Modbus/SNMP/BACnet
Master - 32 Units, Modbus Master BCM H663 - 4 Units, or Modbus Master BCM H663 - 16 Units). This option is selected on the
Modbus/SNMP/ BACnet/Telnet Communication page; see Figure 3.38 on page 96.
If you’re configuring a Branch Circuit Monitor, refer to “Modbus/Slave Units Configuration – Modbus Master Branch Circuit Monitor –
4 or 16” on page 143.
Most frequently, the RIM-1000 will be configured for Modbus/SNMP/BACnet Master - 32 Units, and the following page will display. Use
this page to configure the information regarding the Modbus Slave devices from which the RIM-1000 will poll.
Figure 3.39 Modbus/Snmp/BACnet Slave Unit Configuration Page