Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 116)

Remote Infrastructure Management System - Version 1.0 / July 2014
116 www.chatsworth.com
3. Near the middle of the Configuration screen, you’ll see the same Map Coordinate: X, Y fields, Graphical Mapping link, and
Test Map link you saw on the analog and digital input configuration screen. Click the Graphical Mapping link and drag and
drop the blue rectangle to pinpoint the location of the slave unit.
4. Once you are satisfied with the point’s location, click the “Submit Changes” link. You’ll see a brief System Updating message,
and then be returned to the Modbus/SNMP/BACnet Slave Configuration page. The X and Y coordinate boxes will be populated with
the coordinates you designated. If you would like to fine tune the location by adjusting the coordinates or alter the map box size,
please remember to click the Submit Changes button once your adjustments are complete.
5. Click the Next >> link at the top of the page to map the next device.
NOTE: When you map a slave unit device, you are mapping its physical location. The indicator that appears at the map location is a
clickable link that takes you to a table that details the status of the points monitored by the device. Click the Floor Map link at the
bottom of that page to return to the floor map.
Figure 3.63 Modbus / SNMP Slave Unit Detailed View
3.4.26.2 Add a Link to the RIM-1000 Home Page
You can also add RIM-1000 home page link to the map. The link will appear as a round circle with the letter F in the middle. Clicking on this
image on the map will take you to the RIM-1000 home page.
1. From the FFS home page, go to Configuration>System. At the bottom of the System Configuration page, you’ll see the Map
Coordinate: X, Y fields and the Graphical Mapping link. Click the Graphical Mapping link.
2. Drag and drop the blue circle to designate the location of the link. Once your satisfied with the location, click the Falcon
Unit - Submit Changes link to return to the System Configuration page.
3. If necessary, fine-tune the map coordinates in the X and Y boxes. If you manually adjust the coordinates, you must click the Submit
Changes button to save the adjusted data.
3.4.26.3 Back Up the Map Data
Once you’ve finished mapping all your devices, return to the RIM-1000 home page and click the Floor Map link. Verify the accuracy
of your map. If your map is complete and accurate, it’s time to back up the data.
1. From the RIM-1000 home page, go to Configuration>Flash Program
2. Click the link that says Download FCF Configuration File (.xfg - 128k)
3. If you’re using Internet Explorer, a File Download pop-up will appear. Click the Save button. Navigate to the location where
you’d like to save the file. You can use any file name, but the file name MAY NOT contain spaces, and must be
a .xfg file format.