Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 153)

Remote Infrastructure Management System - Version 1.0 / July 2014
Chatsworth Products, Inc. (CPI) • 800-834-4969 153
5.3.1 Network Configuration – netcfg
Typing netcfg at the command prompt on the Main Menu displays the Network Configuration Menu that lists all items for
system setup and configuration. This menu may be password protected. If it is, the password must be entered when the SC
menu selection is made. To enter the password, type SC, press the space bar once, and then type the appropriate
password; see Table 5.2 for the Main Configuration Menu Options.
Table 5.2 Main Configuration Menu Options (SC)
Command Description Function
mac
Media Access
Control MAC will display the current MAC address for the RIM-1000. The MAC
address should never be changed on the RIM-1000, if it needs to be
changed, contact CPI.
ip
Internet
Protocol IP is the network address that is part of the TCP/IP protocol
suite for the RIM-1000 to communicate over the network.
nm Subnet Mask nm allows users to configure the subnet mask address for the network.
dg
Default
Gateway dg allows the user to configure the default gateways/router
address for the network.
ping ICMP
ping allows users to send a communication request to other network
device top check for network conductivity.
nd
Network
Debug nd allows users to troubleshoot the network devices seen
by the RIM-1000.
ns
Network
Statistics
ns allows users to view the network activity seen by the RIM-1000.
arp
Address
Resolution
Protocol
arp allows users to view the arp table entries by the RIM-1000.
mt1 Mail Trace 1
mt1 allows users a simple view of the communications between the mail
server and RIM-1000 while trying to sending an email.
mt2 Mail Trace 2
mt2 allows users a detailed view of the communications between the mail
server and RIM-1000 while sending an email.
tm Test Mail
tm allows users to generate a test email from the RIM-1000 to the mail
server. Users can view the communication between the RIM-1000 and mail
server. The email page must be configured for this test feature to work.