Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 150)

Remote Infrastructure Management System - Version 1.0 / July 2014
150 www.chatsworth.com
4.8.3 Telnet Communication
To access a device through the RIM-1000:
1. Open a Command Prompt window and type the following:
Telnet[sp](RIM-1000 IP address)[sp](Port number)
Telnet Communication, IP Address of 10.0.0.108, Port 3201
Note: If the RIM-1000 is going to be looped back into itself, the Command Prompt line feed must be set to
carriage return (CR) only.
Do not Telnet back into the RIM-1000. This could cause severe problems, including system freezing or complete
shutdown of the system.
2. Press Enter. The device connects.
Figure 4.17 Example Telnet Connection Showing Specific Parameters
Once a Telnet connection is established, the menu displays for the connected device. Menus vary depending on the device.
Warning