Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 152)

Remote Infrastructure Management System - Version 1.0 / July 2014
152 www.chatsworth.com
5.2. Flash Executable Code
After the boot up sequence, the main program executes from Flash memory. In order to run properly, the unit must have a
unique MAC address (assigned by the manufacturer) and an IP address. The factory default for the IP address is 10.0.0.188.
If the unit is connected to the enterprise's network, an IP address must be obtained from the network administrator. The
RIM-1000 must be reconfigured with this new IP address. This reconfiguration can be done in the field; see the Table 5.1.
Once the system reaches this point, press Enter to display the System Main Menu.
5.3. Main Menu
All system functions begin in the Main Menu. Users can display information, execute commands and display submenus for
additional inquiry and system configuration functions.
Table 5.1 EIA-232 Main Menu
Command Description Function
netcfg
Network
Configuration
netcfg displays the current MAC address, IP address, subnet mask, default
gateway. Users can set the MAC address, IP address, Subnet mask, default
gateway, ping, network debug, network statistics, arp table, mail trace1,
mail trace2 and test email.
time
Display Date/
Time
time displays the RIM-1000 current time and date. To enter the time
manually, type time one space then the current time in 24 hour format,
including the seconds; e.g., hh:mm:ss
date
Display Date/
Time date displays the RIM-1000 current time and date. To enter the date
manually, type date one space then the current time date; e.g., mm/dd/yy.
reset
bootloader
Menu
reset displays the RIM-1000 bootloader menu. The options are mac, ip,
nm, dg, nd, ns, arp, ping, time, date, reset, id, blank, erase prgm, load prgm
xmodem, erase saX, run, diag and rlyx.
id
Firmware
Identification id displays the RIM-1000 unit name, firmware file name and file
size.