Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 11)

Remote Infrastructure Management System - Version 1.0 / July 2014
Chatsworth Products, Inc. (CPI) • 800-834-4969 11
4 Advanced Communications - Modbus, BACnet, and Telnet 129
Figure 4.1 RIM-1000 Modbus EIA-232 Connection to an EIA-232 DCE Device 130
Figure 4.2 RIM-1000 Modbus EIA-232 Connection to an EIA-232 DTE Device 131
Figure 4.3 EIA-485 Wiring Connections 132
Figure 4.4 EIA-485 Wiring to RLE/Veris BCMs (Branch Circuit Monitors) 133
Figure 4.5 Modbus Slave Register Display Log 134
Figure 4.6 Modbus Packet Log 136
Figure 4.7 Modbus Master Poll Data Log 137
Figure 4.8 Input and Relay Configuration Menu 138
Figure 4.9 Modbus Register Configuration Menu 139
Figure 4.10 Individual Modbus Register Configuration Screen 140
Figure 4.11 Read/Preset Single Register Page 142
Figure 4.12 Modbus BCM-4 Unit Configuration 143
Figure 4.13 Modbus Registers (BCM) Page 144
Figure 4.14 Circuit Breaker Configurations for Individual BCMs 145
Figure 4.15 RIM-1000 Connection to an EIA-232 Device 148
Figure 4.16 Modbus/SNMP/BACnet/Telnet Configuration Page 149
Figure 4.17 Example Telnet Connection Showing Specific Parameters 150
5 EIA-232 Interface 151
6 Remote Access 157
Figure 6.1 RIM-1000 Dial-Up Menu 158
7 Point-to-Point Protocol 159
8 Load Firmware and Configuration Data 161
Figure 8.1 Flash Program Configuration Page 162
Figure 8.2 Choose the Firmware File 162
Figure 8.3 Firmware Load Messages 163
Figure 8.4 Flash Copy Prompt 163
Figure 8.5 Flash Overwriting Message 163
Figure 8.6 Current Firmware Version As Shown in RIM-1000 Interface 164
Figure 8.7 Save Configuration File (Flash Program Configuration Page) 167
Figure 8.8 Load Configuration File (Flash Program Configuration Page) 168
A RIM-1000 Expansion Cards 169
Figure A.1 Back of 2U RIM-1000 Showing Hex Standoffs and Screws to Remove 170
Figure A.2 Side Plate with Two Mounting Screws Removed; Slide the Base and Cover Apart 170
Figure A.3 2U RIM-1000 Unit - Opened 171
Figure A.4 SW2 DIP Switches 171
Figure A.5 Expansion Card with Ribbon Cable Attached 172
Figure A.6 Expansion Card Mounting in a Two-Rack Unit 172
Figure A.7 Expansion Card Final Placement in a Two-Rack Unit 173
Figure A.8 Expansion Card Current Channel (4-20mA) Configuration 175
Figure A.9 Expansion Card Voltage Channel (0-5V or 0-10V) Configuration 175
B Analog Averaging 177
C Analog Input 4-20mA Reference Chart 179