Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 70)

Remote Infrastructure Management System - Version 1.0 / July 2014
70 www.chatsworth.com
3.4.11.1 RIM-1000 Nest Configuration
The RIM-1000 Nest link appears at top right corner of the Home Page once the Nest and Eggs have been configured. The Nest can
display either as a table or a map, with the Eggs appearing as links on the map. The nest map is created in much the same way
as the RIM-1000 floor map, and the instructions are very similar. Basic mapping directions can be found below. For more detailed
mapping instructions, refer to “Map (Facility Mapping)” on page 109.
Figure 3.23 Nest/Egg Configuration Page
Table 3.12 Nest/Egg Configuration Options
Option Description
Nest Type
Select IFrames to display the eggs in a table. Select Map Image to
display the eggs on a map.
Home Nest Map Link
When you click on a link to an RIM-1000 Egg, you can either go to that
Egg’s home page or to the floor map of that RIM-1000 Egg. Select the
appropriate option here.
Egg Login
Egg devices will be connected to this nest, and these devices may ask for a login.
Decide if the user should be required to supply a login to view the map of a
device connected to this nest as an egg.
Referred - Nologin: If the user gets to the egg device from a referral link, they
will not be required to login.
Always login: users will always be required to log into the egg device
Default: Referred - Nologin
Nest Refresh Rate
Determine how often you’d like the Nest view to refresh.
Default: 30 seconds
Egg Refresh Rate
Decide how often you’d like the Egg view to refresh.
Default: 30 seconds