Eppendorf epBlue with MultiCon - Manual (Page 158)

epBlue - Software error messages
epBlue™ with MultiCon
English (EN)
158
0x1911 The following
labware has been
changed, so the
pattern no longer
fits: xxx Because the order or contents
of a “Equipped Holder”
combination can be changed,
the recent pattern of a
command may not fit the new
positions of the tubes.  Either change the order or
contents of the “Equipped
Holder” combination back
to the original or change
the pattern in the
command.
0x1A02 The name is already
used for another
labware
Edit mode/labware:
The same name has been
defined for a different rack or
another labware item.  Enter a different name.
0x1A03 This position is not
available for the
selected labware Edit mode/worktable:
Certain worktable positions
are not allowed for specific
labware (e.g., tips can only be
placed in the rear of the
worktable).  Place the selected labware
in another location.
0x1A04 The selected
labware may not be
stacked on top of
labware already
placed Edit mode/worktable:
Building of labware stacks on
the worktable is restricted to
certain labware combinations
(e.g., thermorack above
thermorack does not make
sense).  See "Cause".
0x1A05 Maximum number
of labware stacked:
5 Edit mode/worktable:
Certain labware build a pile
which contains too many
when placed on certain
labware. Place the selected labware in
another location.
0x1A06 Labware stack too
high in location:
xxx
Maximum height:
xxx mm Edit mode/worktable:
Labware stacks on the
worktable may not exceed a
maximum height limit (e.g.,
plates on adapters is allowed;
reservoir holder on adapters is
not allowed because the stack
would be too high).  See "Cause".
0x1A10 8-channel tool
cannot be used for
this source rack Edit mode/parameter in
command
Sample Transfer :
Source rack does not fit the
8-channel tool (e.g., 24-well
plate or tube rack with
24
positions).
 Choose another rack or
another tool.
Code Symptom/message Cause Remedy