Eppendorf epBlue with MultiCon - Manual (Page 28)

epBlue Application Runner - Carrying out the application
epBlue™ with MultiCon
English (EN)
28
4.2.4 Placing the labware on the epMotion worktable
 Position the labware on the epMotion worktable according to the application.
Additional information on positioning the labware can be found in the hardware operating manual.
4.2.5 Setting the run parameters for the optical sensor
If you have the epBlue ID module, the Use bar codes checkbox will appear in the window.
In the application, you defined the application parameters for the optical sensor. You can enter run
parameters to use other settings of the optical sensor for an individual run. The run parameters overwrite
the application parameters for this run only (see Optical sensor on p. 80).
Abb. 4-5: Setting the run parameters
Fig. 4-5: Setting the run parameters
Use Barcodes checkbox
Activate ID tracking.
Detect volumes radio button
Activate the Detect volumes function. The
parameters set in the application for the labware
are used.
Use required minimum volumes radio button
epBlue assumes that all vessels are filled with the
minimum required volume for this run. Use this
function for dry runs.
Input volumes manually radio button
Deactivate the Detect volumes function. You have
to enter the sample volume manually.
Detect tips checkbox
Activate the Detect tips function.
Check labware placement checkbox
Activate the Check labware placement function.