Det-Tronics EQP Fire and Gas Detection/Releasing System - Manual (Page 110)

14.1 95-8533 5-8
REPLACEMENT PARTS
Eagle Quantum Premier devices are not designed to
be repaired in the field. If a problem should develop,
first carefully check for proper wiring, programming
and calibration. If it is determined that the problem is
caused by an electronic defect, the device must be
returned to the factory for repair.
Note
When replacing a device, be sure that all rocker
switches on the replacement are set the same
as the original device. Consult the settings
documented during system installation and
setup to determine proper settings for the new
device. Remove power before removing a
device or plugging in a replacement unit. When
a device is replaced, configuration is done
automatically.
DEVICE REPAIR AND RETURN
Prior to returning devices or components, contact the
nearest local Detector Electronics office so that a
Service Order number can be assigned. A written
statement describing the malfunction must
accompany the returned device or component to
expedite finding the cause of the failure.
Pack the unit or component properly. Use sufficient
packing material in addition to an antistatic bag or
aluminum-backed cardboard as protection from
electrostatic discharge.
Return all equipment transportation prepaid to the
factory in Minneapolis.
ORDERING INFORMATION
When ordering, please specify:
Refer to the appropriate model matrix in Appendix G for
the following devices:
EQ3XXX EQP Controller
EQ3700DCIO Discrete Input/Output Module
EQ3710AIM Analog Input Module
EQ3720RM Relay Module
EQ3730EDIO Enhanced Discrete Input/Output Module
EQ3740IPM Intelligent Protection Module
POwER SUPPLIES
Part Number
Description
006979-001 EQ21xxPSM Power Supply Monitor
000604-013 EQ2110PS Power Supply (10 A / 60 Hz)
000604-014 EQ2130PS Power Supply (30 A / 60 Hz)
000604-015 EQ2175PS Power Supply (75 A / 60 Hz)
000604-034 EQ2111PS Power Supply (10 A / 50 Hz)
000604-035 EQ2131PS Power Supply (30 A / 50 Hz)
000604-036 EQ2176PS Power Supply (75 A / 50 Hz)
007941-001 EQ2220GFM Ground Fault Monitor
010988-001 EQP2120PS–B Power Supply,
20A/50-60 Hz, Panel Mount
010988-002 EQP2120PS Power Supply,
20A/50-60 Hz, DIN Rail Mount
010985-001 EQ2110PS–P Power Supply,
10A/50-60 Hz, Panel Mount
010985-002 EQ2110PS Power Supply,
10A/50-60 Hz, DIN Rail Mount
010892-001 EQ2410PS–P Converter,
10A/24 Vdc, Panel Mount
010892-002 EQ2410PS Converter,
10A/24 Vdc, DIN Rail Mount
009934-001 Diode Redundancy Module,
with Mounting Bracket
009934-002 Diode Redundancy Module,
DIN Rail Mount
LON DEVICES
Part Number
Description
006608-xxx EQ22xxIDC Initiating Device Circuit
006943-xxx EQ22xxIDCGF Ground Fault Monitor
007257-xxx EQ22xxIDCSC Initiating Device
Circuit Short Circuit
006607-xxx EQ22xxDCU Digital Communication
Unit (specify gas)
006733-xxx EQ25xxARM Agent Release Module
006738-xxx EQ25xxSAM Signal Audible Module
006941-xxx EQ24xxNE Network Extender
008056-001 HART Interface Module
008982-001 EQ3LTM LON Termination Module