Ce conformity – Rockwell Automation 21G PowerFlex 750-Series AC Drives User Manual
Page 13
Rockwell Automation Publication 750-IN001N-EN-P - April 2014
13
PowerFlex 750-Series AC Drives
CE Conformity
Compliance with the Low Voltage Directive and Electromagnetic Compatibility
Directive has been demonstrated using harmonized European Norm (EN)
standards which are referenced by the Official Journal of the European Union.
PowerFlex 750-Series drives comply with the EN standards listed below when
installed according to this PowerFlex 750-Series AC Drive Installation
Instructions.
EU Declarations of Conformity are available online at:
www.rockwellautomation.com/products/certification/
Low Voltage Directive
•
EN 61800-5-1 Adjustable speed electrical power drive systems – Part 5-1:
Safety requirements – Electrical, thermal and energy.
EMC Directive
•
EN 61800-3 Adjustable speed electrical power drive systems – Part 3:
EMC product standard including specific test methods.
General Considerations
•
For EU compliance, drives must satisfy installation requirements related to
both EN 61800-5-1 and EN 61800-3 provided in this document.
•
PowerFlex 750-Series AC Drives comply with the EMC requirements of
EN 61800-3 when installed according to good EMC practices and the
instructions provided in this document. However, many factors can
influence the EMC compliance of an entire machine or installation, and
compliance of the drive itself does not ensure compliance of all
applications.
•
PowerFlex 750-Series drives are not intended to be used on public low-
voltage networks which supply domestic premises. Without additional
mitigation, radio frequency interference is expected if used on such a
network. The installer is responsible to take measures such as
supplementary line filters and enclosures to prevent interference, in
addition to the installation requirements of this document.
•
Requirements for supplementary mitigation related to specific high
frequency emission limits are provided in
.
ATTENTION: NEMA/UL Open Type and Flange Mount drives must either be
installed in a supplementary enclosure or equipped with a “NEMA Type 1 Kit”
to be CE compliant with respect to protection against electrical shock.