Rockwell Automation 21G PowerFlex 750-Series AC Drives - Manual (Page 214)

214 Rockwell Automation Publication 750-IN001N-EN-P - April 2014
PowerFlex 750-Series AC Drives
Hardware Enable Circuitry
Each main control board has one digital input, Digital Input 0, that can be used
as a general purpose programmable input, or by removal of a jumper, configured
as a dedicated hardware enable, which is unaffected by parameter settings.
• PowerFlex 753 - Digital Input 0 is found on TB3
• PowerFlex 755 - Digital Input 0 is found on TB1
To configure Digital Input 0 as a dedicated hardware enable, complete the
following steps.
1. Access the control pod as described beginning on page 206 .
2. Locate and remove ENABLE Jumper on the Main Control Board (see
diagram).
PowerFlex 753 - ENABLE Jumper Location
PowerFlex 755 - ENABLE Jumper Location (Wall Mount Frames 1…7)