Rockwell Automation 21G PowerFlex 750-Series AC Drives - Manual (Page 130)

130 Rockwell Automation Publication 750-IN001N-EN-P - April 2014
PowerFlex 750-Series AC Drives
Reinstall Drive Assembly or Power Option Assembly
After cabinet installation and power wiring is complete, reinstall the drive
assembly or power option assembly in the cabinet.
1. Align the Roll-out Cart and drive assembly or power option with the
cabinet and lock into position according to the procedures described in
Remove Drive Assembly or Power Option Assembly on page 124 .
2. Disengage the capture screws and slowly push the drive assembly or power
option assembly into the cabinet.
3. Secure the assembly-to-cabinet connections then the bus connections.
Refer to
Side Shield and Bus Bar Connections on page 104 for torque
values.