Altera Stratix V Avalon-ST User Manual

Page 100

Advertising
background image

Signal Name

Direction

Description

txfc_max

Output

When asserted, indicates that Transaction Layer has enough

credits to send maximum payload TLPs of all types. Used for

entry into low power state.

txbuf_emp

Output

When asserted, indicates there are no Application Layer TLPs

pending for transmission in the Transaction Layer.

rpbuf_emp

Output

When asserted, indicates the replay buffer contains no TLPs.

dll_req

Output

When asserted, indicates that the Data Link Layer TX path has a

pending request. Used to enable L0s entry or other low-power

state. This is a level sensitive signal.

link_auto_bdw_status

Output

When asserted, indicates that the LTSSM detected an

autonomous bandwidth change which is reported in the

Link

Status Register

.

link_bdw_mng_status

Output

When asserted, indicates that the LTSSM detected a

non-autonomous bandwidth change. Reported in the

Link

Status Register

.

rst_tx_margin_field

Output

When asserted, indicates that the Application Layer should reset

the

Transmit Margin

field of the

Link Control 2 Register

in

the Application Layer’s soft Configuration Space.

rst_enter_comp_bit

Output

When asserted, indicates that the Application Layer should reset

the

Enter Compliance

bit in the

Link Control 2 Register

in

the Application Layer’s soft Configuration Space.

rx_st_ecrcerr[3:0]

Output

Indicates which quad word on

rx_st_data

contains a TLP with

an ECRC error. Only asserted during the cycle that in which the

start of packet is asserted. Only valid only if internal ECRC error

checking is enabled.

err_uncorr_internal

Output

When asserted, indicates an uncorrectable internal error was

detected. This is a real-time active high pulse.

err_corr_internal

Output

When asserted, indicates a corrected internal error (ECC)

detected. This is a real-time active high pulse.

err_tlrcvovf

Output

When asserted, indicates a receiver overflow error. This is a

real-time active high pulse.

txfc_err

Output

When asserted, indicates a TX Flow Control Protocol error. This

is a real-time active high pulse.

5-48

Configuration Space Bypass Mode Interface Signals

UG-01097_avst

2014.12.15

Altera Corporation

Interfaces and Signal Descriptions

Send Feedback

Advertising
This manual is related to the following products: