Exacq exacqVision Pro User Manual User Manual
Page 21
21
The Network tab displays your system’s IP Address, Netmask, Gateway, and Primary DNS server.
NOTE: On a Linux-based system with multiple network interface cards (NICs), the DNS server is the same for all
the NICs in the system. Therefore, changing the DNS on a single NIC changes the DNS for all the NICs in the
system.
1. Select a network connection from the Interfaces list to display its information. Systems with multiple
NICs have more than one entry in the list.
2. Enter the IP Configuration information for the network connection. Gateway and Primary DNS
information is required to connect with a network time server. Click Apply.
3. Select the correct bandwidth setting to limit network traffic from the server to client computers and
iSCSI drives, and click Apply. NOTE: This setting applies to outbound traffic from all NICs in the system.
4. Select the IP Reconnection Settings value in seconds. Click Apply.
1
2
3
4