Exacq exacqVision Pro User Manual - Manual (Page 6)

6 www.exacq.com
1
System Installation Checklist
Quick Start
Installation

See the server’s Quick Start Guide for information on installing the hardware.
Establishing Initial Communications

See the server’s Quick Start Guide for information on establishing initial communications from the client software to an
exacqVision Server.
Configure IP Cameras

See the IP Camera Quick Start Guide for information on configuring the camera IP addresses, usernames, and passwords.
This document can be found at http://www.exacq.com/support/specsheets.html.
Config (Setup) Page (see Chapter 4)
System*

Set exacqVision server for static IP address.

Configure the system name, time, and time zone.
Storage

Ensure all disks are selected for recording except the system drive (“C:\” in Windows or “/mnt/edvr/0” in Linux)

Ensure total disk space matches the expected value.
Add IP Cameras

Add IP cameras to the exacqVision servers.
Camera Recording (IP cameras)

Set resolutions
1
.

Set frame rate 1 .
Camera Recording (analog cameras)

Set resolutions
1
.

Set frame rates 1 .

Disable cameras that are not connected.
Serial Port

Set up serial port for RS-485 mechanical PTZ control.

Set up serial port for input from serial devices.