Exacq exacqVision Pro User Manual - Manual (Page 82)

82 www.exacq.com
9. H.264 Deblocking (available to Administrators and Power Users) enables more detailed decompression on video
displayed in exacqVision Client. Deblocking is available only on certain cameras. It is recommended that you
select By Device, which enables deblocking on all cameras that stream deblocked video. Selecting Enabled will
cause exacqVision to always perform de-blocking decompression even if the video stream is not actually
deblocked. Enabling deblocking can reduce the maximum displayed frame rate, so use it with caution.
10. The VGA Acceleration Mode section (not available in exacqVision Start) resolves display issues caused by the
video card. Selecting Auto should provide the best results for the installed video card. However, you can select
Direct3D or OpenGL, along with a colorspace option from the drop-down list, to determine whether you can
improve the video refresh rate or other display issues. Available acceleration and colorspace options vary
depending on the video card installed.
11. The Timelapse Playback section (not available in exacqVision Start) controls the amount of display time between
video gaps due to time-lapse recording or discontinuous motion. Normally, the system automatically jumps to
the next video frame after a one-second gap. You can decrease the dwell time to zero by sliding the interval
control to the left or increase the dwell time up to 15 seconds by sliding it to the right.
12. The Show Configuration Mode to Operating System Restricted Users checkbox (not available in exacqVision
Start) allows you to hide the Config (Setup) Page button for a client who has a restricted Windows setting. Only
the Live and Search icons are displayed to these restricted users if you select this option.
13. Select Disable Windows Font Smoothing if fonts are not appearing as desired.
14. Select Enable Receiving Display if this client should be available to other exacqVision Client Enterprise computers
for remote control (VideoPush). The display name is the name that will appear in the client title bar on the client
that is connected remotely. See the “VideoPush” section in the “Live Page Overview” chapter for a full
description of the VideoPush feature.
NOTE: The Mac version of exacqVision Client also contains a Use a 24-Hour Clock option on the Client page.
9
10
11
12
13
14