Configuring the p2p network type for an interface, Configuring ospf route control, Ospf route redistribution configuration example – H3C Technologies H3C S12500-X Series Switches User Manual
Page 113
99
--- Ping statistics for 10.4.1.1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 0.779/1.408/1.702/0.323 ms
237B
OSPF route redistribution configuration example
504B
Network requirements
•
Enable OSPF on all the switches.
•
Split the AS into three areas.
•
Configure Switch A and Switch B as ABRs.
•
Configure Switch C as an ASBR to redistribute external routes (static routes).
Figure 23 Network diagram
505B
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Enable OSPF (see "
995H
Basic OSPF configuration example
").
3.
Configure OSPF to redistribute routes:
# On Switch C, configure a static route destined for network 3.1.2.0/24.
<SwitchC> system-view
[SwitchC] ip route-static 3.1.2.1 24 10.4.1.2
# On Switch C, configure OSPF to redistribute static routes.
[SwitchC] ospf 1
[SwitchC-ospf-1] import-route static
506B
Verifying the configuration
# Display the ABR/ASBR information of Switch D.
<SwitchD> display ospf abr-asbr
OSPF Process 1 with Router ID 10.5.1.1
Routing Table to ABR and ASBR
Type Destination Area Cost Nexthop RtType
Intra 10.3.1.1 0.0.0.2 10 10.3.1.1 ABR
Inter 10.4.1.1 0.0.0.2 22 10.3.1.1 ASBR