H3C Technologies H3C S12500-X Series Switches - Manual (Page 95)

81
Step Command Remarks
3. Specify the SPF
calculation interval.
spf-schedule-interval
maximum-interval [ minimum-interval
[ incremental-interval ] ]
By default:
• The maximum interval is 5 seconds.
• The minimum interval is 50
milliseconds.
• The incremental interval is 200
milliseconds.
211B
Specifying the LSA arrival interval
If OSPF receives an LSA that has the same LSA type, LS ID, and router ID as the previously received LSA
within the LSA arrival interval, OSPF discards the LSA to save bandwidth and route resources.
To configure the LSA arrival interval:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
3. Configure the LSA arrival
interval.
lsa-arrival-interval interval
The default setting is 1000
milliseconds.
Make sure this interval is smaller than
or equal to the interval set with the
lsa-generation-interval command.
212B
Specifying the LSA generation interval
Adjust the LSA generation interval to protect network resources and routers from being overwhelmed by
LSAs at the time of frequent network changes.
When network changes are not frequent, LSAs are generated at the minimum-interval. If network
changes become frequent, the LSA generation interval is incremented by incremental-interval × 2 n-2 (n is
the number of generation times) each time a LSA generation occurs until the maximum-interval is
reached.
To configure the LSA generation interval:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A