H3C Technologies H3C S12500-X Series Switches - Manual (Page 364)

350
Step Command Remarks
12. Specify the maximum
number of ECMP routes for
load balancing.
ipv6 maximum load-balancing number
By default, the maximum
number of ECMP routes is
the same as that configured
in the max-ecmp-num
command.
For more information about
the max-ecmp-num
command, see Layer 3—IP
Routing Command
Reference.
117B
Tuning and optimizing IPv6 IS-IS networks
418B
Configuration prerequisites
Before you tune and optimize IPv6 IS-IS networks, complete basic IPv6 IS-IS tasks.
419B
Assigning a convergence priority to IPv6 IS-IS routes
A topology change causes IS-IS routing convergence. To improve convergence speed, you can assign
convergence priorities to IPv6 IS-IS routes. Convergence priority levels are critical, high, medium, and low.
The higher the convergence priority, the faster the convergence speed.
By default, IPv6 IS-IS host routes have medium convergence priority, and other IPv6 IS-IS routes have low
convergence priority.
To assign a convergence priority to specific IPv6 IS-IS routes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Assign a convergence priority
to specific IPv6 IS-IS routes.
ipv6 priority { critical | high |
medium } { prefix-list
prefix-list-name | tag tag-value }
By default, IPv6 IS-IS routes, except
IPv6 IS-IS host routes, have the low
convergence priority.
118B
Configuring BFD for IPv6 IS-IS
Bidirectional forwarding detection (BFD) can quickly detect faults between IPv6 IS-IS neighbors to
improve the convergence speed of IPv6 IS-IS. For more information about BFD, see High Availability
Configuration Guide.
To configure BFD for IPv6 IS-IS: