Enhancing is-is network security, Configuration prerequisites, Advertising optimal routes in the ip routing table – H3C Technologies H3C S12500-X Series Switches User Manual
Page 215
201
Step Command
Remarks
4.
Create a summary route in the
BGP routing table.
aggregate ip-address { mask |
mask-length } [ as-set |
attribute-policy route-policy-name
| detail-suppressed | origin-policy
route-policy-name |
suppress-policy
route-policy-name ] *
By default, no summary route is
configured.
To configure BGP manual route summarization (IPv6):
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Enter BGP IPv6 unicast
address family view.
address-family ipv6 [ unicast ]
N/A
4.
Create a summary route in the
IPv6 BGP routing table.
aggregate ipv6-address
prefix-length [ as-set |
attribute-policy route-policy-name
| detail-suppressed | origin-policy
route-policy-name |
suppress-policy
route-policy-name ] *
By default, no summary route is
configured.
315B
Advertising optimal routes in the IP routing table
By default, BGP advertises optimal routes in the BGP routing table, which might not be optimal in the IP
routing table. This task allows you to advertise BGP routes that are optimal in the IP routing table to all
BGP peers.
To enable BGP to advertise optimal routes in the IP routing table:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Enable BGP to advertise
optimal routes in the IP routing
table.
advertise-rib-active
By default, BGP advertises optimal
routes in the BGP routing table.
316B
Advertising a default route to a peer or peer group
Perform this task to advertise a default BGP route with the next hop being the advertising router to a peer
or peer group.
To advertise a default route to a peer or peer group (IPv4):