H3C Technologies H3C S12500-X Series Switches - Manual (Page 81)

67
Tasks at a glance
(Optional.)
966H
Tuning and optimizing OSPF networks :
•
967H
Configuring OSPF timers
•
968H
Specifying LSA transmission delay
•
969H
Specifying SPF calculation interval
•
970H
Specifying the LSA arrival interval
•
971H
Specifying the LSA generation interval
•
972H
Disabling interfaces from receiving and sending OSPF packets
•
973H
Configuring stub routers
•
974H
Configuring OSPF authentication
•
975H
Adding the interface MTU into DD packets
•
976H
Configuring a DSCP value for OSPF packets
•
977H
Configuring the maximum number of external LSAs in LSDB
•
978H
Configuring OSPF exit overflow interval
•
979H
Enabling compatibility with RFC 1583
•
980H
Logging neighbor state changes
•
981H
Configuring OSPF network management
•
982H
Configuring the LSU transmit rate
•
983H
Enabling OSPF ISPF
•
984H
Configuring prefix suppression
•
985H
Configuring prefix prioritization
•
986H
Configuring OSPF PIC
(Optional.)
987H
Configuring OSPF GR
•
988H
Configuring the OSPF GR restarter
•
989H
Configuring OSPF GR helper
•
990H
Triggering OSPF GR
(Optional.)
991H
Configuring BFD for OSPF
(Optional.)
992H
Configuring OSPF FRR
44B
Enabling OSPF
Enable OSPF before you perform other OSPF configuration tasks.
186B
Configuration prerequisites
Configure the link layer protocol and IP addresses for interfaces to ensure IP connectivity between
neighboring nodes.
187B
Configuration guidelines
To enable OSPF on an interface, you can enable OSPF on the network where the interface resides or
directly enable OSPF on that interface. If you configure both, the latter takes precedence.
You can specify a global router ID, or specify a router ID when you create an OSPF process: