H3C Technologies H3C S12500-X Series Switches User Manual

Page 287

Advertising
background image

273

633B

Configuration procedure

1.

Configure IP addresses for interfaces. (Details not shown.)

2.

Configure OSPF to make sure that Switch A and Switch C are reachable to each other. (Details not
shown.)

3.

Configure BGP on Switch A:
# Establish two IBGP connections to Switch C.

<SwitchA> system-view

[SwitchA] bgp 200

[SwitchA-bgp] peer 3.0.2.2 as-number 200

[SwitchA-bgp] peer 2.0.2.2 as-number 200

[SwitchA-bgp] address-family ipv4 unicast

[SwitchA-bgp-ipv4] peer 3.0.2.2 enable

[SwitchA-bgp-ipv4] peer 2.0.2.2 enable

[SwitchA-bgp-ipv4] quit

[SwitchA-bgp] quit

# Create ACL 2000 to permit 1.1.1.0/24 to pass.

[SwitchA] acl number 2000

[SwitchA-acl-basic-2000] rule permit source 1.1.1.0 0.0.0.255

[SwitchA-acl-basic-2000] quit

# Create two route policies, apply_med_50 and apply_med_100. Policy apply_med_50 sets the

MED for route 1.1.1.0/24 to 50. Policy apply_med_100 sets that to 100.

[SwitchA] route-policy apply_med_50 permit node 10

[SwitchA-route-policy-apply_med_50-10] if-match ip address acl 2000

[SwitchA-route-policy-apply_med_50-10] apply cost 50

[SwitchA-route-policy-apply_med_50-10] quit

[SwitchA] route-policy apply_med_100 permit node 10

[SwitchA-route-policy-apply_med_100-10] if-match ip address acl 2000

[SwitchA-route-policy-apply_med_100-10] apply cost 100

[SwitchA-route-policy-apply_med_100-10] quit

# Apply routing policy apply_med_50 to routes outgoing to peer 3.0.2.2, and apply routing
policy apply_med_100 to routes outgoing to peer 2.0.2.2.

[SwitchA] bgp 200

[SwitchA-bgp] address-family ipv4 unicast

[SwitchA-bgp-ipv4] peer 3.0.2.2 route-policy apply_med_50 export

[SwitchA-bgp-ipv4] peer 2.0.2.2 route-policy apply_med_100 export

[SwitchA-bgp-ipv4] quit

# Enable BFD for peer 3.0.2.2.

[SwitchA-bgp] peer 3.0.2.2 bfd

[SwitchA-bgp] quit

4.

Configure BGP on Switch C:
# Establish two IBGP connections to Switch A.

<SwitchC> system-view

[SwitchC] bgp 200

[SwitchC-bgp] peer 3.0.1.1 as-number 200

[SwitchC-bgp] peer 2.0.1.1 as-number 200

[SwitchC-bgp] address-family ipv4 unicast

Advertising
This manual is related to the following products: