H3C Technologies H3C S12500-X Series Switches - Manual (Page 321)

307
2. When a RIPng neighbor receives the request packet, it sends back a response packet that contains
the local routing table. RIPng can also advertise route updates in response packets periodically or
advertise a triggered update caused by a route change.
3. After RIPng receives the response, it checks the validity of the response before adding routes to its
routing table, such as whether the source IPv6 address is the link-local address and whether the
port number is correct. A response packet that fails the check is discarded.
371B
Protocols and standards
• RFC 2080, RIPng for IPv6
• RFC 2081, RIPng Protocol Applicability Statement
96B
RIPng configuration task list
Tasks at a glance
(Required.)
1185H
Configuring basic RIPng
(Optional.)
1186H
Configuring RIPng route control :
•
1187H
Configuring an additional routing metric
•
1188H
Configuring RIPng route summarization
•
1189H
Advertising a default route
•
1190H
Configuring received/redistributed route filtering
•
1191H
Configuring a preference for RIPng
•
1192H
Configuring RIPng route redistribution
(Optional.)
1193H
Tuning and optimizing the RIPng network :
•
1194H
Configuring RIPng timers
•
1195H
Configuring split horizon and poison reverse
•
1196H
Configuring zero field check on RIPng packets
•
1197H
Configuring the maximum number of ECMP routes
(Optional.)
1198H
Configuring RIPng GR
97B
Configuring basic RIPng
Before you configure basic RIPng, configure IPv6 addresses for interfaces to ensure IPv6 connectivity
between neighboring nodes.
To configure basic RIPng:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a RIPng process and
enter its view.
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
By default, the RIPng process is not
created.
3. Return to system view. quit N/A