H3C Technologies H3C S12500-X Series Switches - Manual (Page 382)

368
14B
Configuring routing policies
Routing policies control routing paths by filtering and modifying routing information. This chapter
describes both IPv4 and IPv6 routing policies.
127B
Overview
Routing policies can filter advertised, received, and redistributed routes, and modify attributes for specific
routes.
To configure a routing policy:
1. Configure filters based on route attributes, such as destination address and the advertising router's
address.
2. Create a routing policy and apply filters to the routing policy.
431B
Filters
Routing policies can use the following filters to match routes.
695B
ACL
ACLs include IPv4 ACLs and IPv6 ACLs. An ACL can match the destination or next hop of routing
information.
For more information about ACLs, see ACL and QoS Configuration Guide.
696B
IP prefix list
IP prefix lists include IPv4 prefix lists and IPv6 prefix lists.
An IP prefix list matches the destination address of routing information. You can use the gateway option
to receive routing information only from specific routers. For more information about the gateway option,
see "
1248H
Configuring RIP " and "
1249H
Configuring OSPF ."
An IP prefix list, identified by name, can comprise multiple items. Each item, identified by an index
number, specifies a prefix range to match. An item with a smaller index number is matched first. A route
that matches one item matches the IP prefix list.
697B
AS path list
An AS path list matches the AS_PATH attribute of BGP routing information.
For more information about AS path lists, see "
1250H
Configuring BGP ."
698B
Community list
A community list matches the COMMUNITY attribute of BGP routing information.
For more information about community lists, see "
1251H
Configuring BGP ."
699B
Extended community list
An extended community list matches the extended community attribute (Route-Target for VPN) of BGP
routing information.