H3C Technologies H3C S12500-X Series Switches - Manual (Page 80)

66
• RFC 3137, OSPF Stub Router Advertisement
• RFC 4811, OSPF Out-of-Band LSDB Resynchronization
• RFC 4812, OSPF Restart Signaling
• RFC 4813, OSPF Link-Local Signaling
43B
OSPF configuration task list
To run OSPF, you must first enable OSPF on the router. Make a proper configuration plan to avoid
incorrect settings that can result in route blocking and routing loops.
To configure OSPF, perform the following tasks:
Tasks at a glance
(Required.)
942H
Enabling OSPF
(Optional.)
943H
Configuring OSPF areas :
•
944H
Configuring a stub area
•
945H
Configuring an NSSA area
•
946H
Configuring a virtual link
(Optional.)
947H
Configuring OSPF network types :
•
948H
Configuring the broadcast network type for an interface
•
949H
Configuring the NBMA network type for an interface
•
950H
Configuring the P2MP network type for an interface
•
951H
Configuring the P2P network type for an interface
(Optional.)
952H
Configuring OSPF route control :
•
953H
Configuring OSPF route summarization
{
954H
Configuring route summarization on an ABR
{
955H
Configuring route summarization when redistributing routes into OSPF on an ASBR
•
956H
Configuring received OSPF route filtering
•
957H
Configuring Type-3 LSA filtering
•
958H
Configuring an OSPF cost for an interface
•
959H
Configuring the maximum number of ECMP routes
•
960H
Configuring OSPF preference
•
961H
Configuring OSPF route redistribution
{
962H
Configuring OSPF to redistribute routes from another routing protocol
{
963H
Configuring OSPF to redistribute a default route
{
964H
Configuring default parameters for redistributed routes
•
965H
Advertising a host route