H3C Technologies H3C S12500-X Series Switches - Manual (Page 55)

41
[SwitchB-rip-1] quit
# Display the RIP routing table on Switch A.
[SwitchA] display rip 100 route
Route Flags: R - RIP
A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------------------
Peer 192.168.1.2 on Vlan-interface100
Destination/Mask Nexthop Cost Tag Flags Sec
10.1.1.0/24 192.168.1.2 1 0 RAOF 19
# Display the RIP routing table on Switch B.
[SwitchB] display rip 1 route
Route Flags: R - RIP
A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------------------
Peer 192.168.1.3 on Vlan-interface100
Destination/Mask Nexthop Cost Tag Flags Sec
172.16.1.0/24 192.168.1.3 1 0 RAOF 19
170B
Configuring RIP route redistribution
468B
Network requirements
As shown in
930H
Figure 8 , Switch B communicates with Switch A through RIP 100 and with Switch C through
RIP 200.
Configure RIP 200 to redistribute direct routes and routes from RIP 100 on Switch B so Switch C can learn
routes destined for 10.2.1.0/24 and 11.1.1.0/24. Switch A cannot learn routes destined for 12.3.1.0/24
and 16.4.1.0/24.
Figure 8 Network diagram
469B
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP:
# Enable RIP 100, and configure RIPv2 on Switch A.
<SwitchA> system-view
[SwitchA] rip 100
[SwitchA-rip-100] network 10.0.0.0
[SwitchA-rip-100] network 11.0.0.0
[SwitchA-rip-100] version 2