H3C Technologies H3C S12500-X Series Switches - Manual (Page 335)

321
Tasks at a glance
(Optional.)
1217H
Tuning and optimizing OSPFv3 networks :
•
1218H
Configuring OSPFv3 timers
•
1219H
Specifying LSA transmission delay
•
1220H
Configuring a DR priority for an interface
•
1221H
Specifying SPF calculation interval
•
1222H
Specifying the LSA generation interval
•
1223H
Ignoring MTU check for DD packets
•
1224H
Disabling interfaces from receiving and sending OSPFv3 packets
•
1225H
Enabling the logging of neighbor state changes
•
1226H
Configuring the LSU transmit rate
(Optional.)
1227H
Configuring OSPFv3 GR :
•
1228H
Configuring GR restarter
•
1229H
Configuring GR helper
(Optional.)
1230H
Configuring BFD for OSPFv3
105B
Enabling OSPFv3
Before you enable OSPFv3, configure IPv6 addresses for interfaces to ensure IPv6 connectivity between
neighboring nodes.
To enable an OSPFv3 process on a router:
• Enable the OSPFv3 process globally.
• Assign the OSPFv3 process a router ID.
• Enable the OSPFv3 process on related interfaces.
The router ID uniquely identifies the router within an AS. If a router runs multiple OSPFv3 processes, you
must specify a unique router ID for each process.
An OSPFv3 process ID has only local significance. Process 1 on a router can exchange packets with
process 2 on another router.
To enable OSPFv3:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable an OSPFv3 process
and enter its view. ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
By default, no OSPFv3 process is
enabled.
3. Specify a router ID. router-id router-id
By default, no router ID is
configured.
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable an OSPFv3 process on
the interface. ospfv3 process-id area area-id
[ instance instance-id ] No OSPFv3 process is enabled on
an interface by default.