H3C Technologies H3C S7500E Series Switches - Manual (Page 112)

6-16
FTP Server Configuration Example (Distributed IRF Device)
Network requirements
z As shown in Figure 6-5 , Device is a IRFsystem, which is composed of a master and a slave. The
member ID of the master is 1, and the slot numbers of the AMB and the SMB on the master are 0
and 1 respectively. The member ID of the slave is 2, and the slot numbers of the AMB and SMB
on the slave are 0 and 1 respectively.
z Device serves as an FTP server and PC as the FTP client. Their IP addresses are as shown in the
following figure. Device and PC are reachable to each other.
z Device downloads a startup file from PC for upgrade, and uploads the configuration file to PC for
backup.
z On PC, an FTP user account has been created for the FTP client, with the username being abc
and the password being pwd.
Figure 6-5 Network diagram for FTPing a startup file from an FTP server
Configuration procedure
If the available memory space of the device is insufficient, use the fixdisk command to clear the
memory or use the delete /unreserved file-url command to delete the files not in use and then perform
the following operations.
1) Configure Device (FTP Server)
# Create an FTP user account ftp, set its password to pwd and the user privilege level to level 3 (the
manage level). Authorize ftp’s access to the root directory of the flash on the AMB of the IRF, and
specify ftp to use FTP.
<Sysname> system-view
[Sysname] local-user ftp
[Sysname-luser-ftp] password simple pwd
[Sysname-luser-ftp] authorization-attribute work-directory level 3
[Sysname-luser-ftp] authorization-attribute work-directory flash:/
To access an SMB of the IRF (suppose that the member ID and slot number of the member device
where the SMB resides are 2 and 1 respectively), you must configure the following: