H3C Technologies H3C S7500E Series Switches - Manual (Page 36)

1-25
Modifying the Level of a Command
All the commands in a view are defaulted to different levels. The administrator can change the default
level of a command to a lower level or a higher level as needed.
Follow these steps to modify the command level:
To do… Use the command… Remarks
Enter system view system-view —
Configure the command level in a
specified view
command-privilege level level
view view command
Required
See Table 1-5 for the default
settings.
You are recommended to use the default command level or modify the command level under the
guidance of professional staff. An improper change of the command level may bring inconvenience to
your maintenance and operation, or even potential security problems.
Saving the Current Configuration
On the device, you can input the save command in any view to save all the submitted and executed
commands into the configuration file. Commands saved in the configuration file can survive a reboot.
The save command does not take effect on one-time commands, such as display commands, which
display specified information, and the reset commands, which clear specified information. The
one-time commands executed are never saved.
Displaying and Maintaining CLI
To do… Use the command… Remarks
Display defined command aliases
and the corresponding commands
display command-alias [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display the clipboard information
display clipboard [ | { begin |
exclude | include }
regular-expression ]
Available in any view