H3C Technologies H3C S7500E Series Switches - Manual (Page 87)

4-2
To do… Use the command… Remarks
Enable SNMP agent snmp-agent
Optional
Disabled by default.
You can enable SNMP agent with this
command or any command that
begins with snmp-agent.
Configure an SNMP group
and specify its access right
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Required
By default, no SNMP group is
configured.
Add a user to the SNMP
group
snmp-agent usm-user v3
user-name group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode
{ 3des | aes128 | des56 }
priv-password ] ] [ acl acl-number ]
Required
If the cipher keyword is specified,
both auth-password and
priv-password are cipher text
passwords.
Follow these steps to configure SNMPv1 and SNMPv2C settings:
To do… Use the command… Remarks
Enter system view system-view —
Enable SNMP agent snmp-agent
Optional
Disabled by default.
You can enable SNMP agent
with this command or any
command that begins with
snmp-agent.
Create or update MIB view information
snmp-agent mib-view
{ excluded | included }
view-name oid-tree [ mask
mask-value ]
Optional
By default, the MIB view
name is ViewDefault and
OID is 1.
Configure
SNMP NMS
access right
Directly
Configure an
SNMP
community
snmp-agent community
{ read | write }
community-name [ acl
acl-number | mib-view
view-name ]*
Required
Use either approach.
The direction configuration
approach is for SNMPv1 or