Configuration task list – H3C Technologies H3C S7500E Series Switches User Manual
Page 137
9-6
z
The current configurations are wrong; and there are too many wrong configurations to locate or to
correct one by one. Rolling back the current configuration to a correct one is needed.
z
The application environment has changed and the device has to run in a configuration state based
on a previous configuration file without being rebooted.
Set configuration rollback following these steps:
1) Specify the filename prefix and path for saving the current configuration.
2) Save the current running configuration with the specified filename (filename prefix + serial number)
to the specified path. The current running configuration can be saved in two ways: the system
saves the current running configuration at a specified interval; or you can save the current running
configuration as needed.
3) Roll back the current running configuration to the configuration state based on a saved
configuration file. When the related command is entered, the system first compares and then
processes the differences between the current running configuration and the specified
replacement configuration file:
z
The rollback operation does not execute the commands that are the same in the replacement
configuration file and in the current configuration file.
z
The rollback operation removes the commands only present in the current configuration file but
not in the replacement configuration file; namely, the corresponding undo form commands are
executed.
z
The rollback operation executes the commands only present in the replacement configuration file
but not in the current configuration file.
z
The rollback operation removes the commands that are different in the replacement configuration
file and in the current configuration file, and then executes them according to the replacement
configuration file.
z
The current running configuration is only saved to the AMB, and only the configuration on the AMB
can be rolled back. However, the related configuration will be synchronized to the SMB to ensure
the rollback of the configuration after an active/standby switchover. (distributed device)
z
The current running configuration is only saved to the AMB of a IRF, and only the configuration on
the AMB can be rolled back. However, the related configuration will be synchronized to the SMBs
of the IRF to ensure the rollback of the configuration after the AMB of the IRF is changed.
(distributed IRF device)
Configuration Task List
Complete these tasks to configure the configuration rollback:
Task
Remarks
Configuring Parameters for Saving the Current Running Configuration
Required