Network requirements – H3C Technologies H3C S7500E Series Switches User Manual
Page 119
7-5
If the available memory space of the device is not enough, use the fixdisk command to clear the
memory or use the delete /unreserved file-url command to delete the files not in use and then perform
the following operations.
# Download application file newest.app from PC to the device.
z
Download application file newest.app from PC to the root directory of the storage medium on the
AMB.
<Sysname> tftp 1.2.1.1 get newest.app
z
Download application file newest.app from PC to the root directory of the storage medium on the
SMB (in slot 1).
<Sysname> tftp 1.2.1.1 get newest.app slot1#flash:/newest.app
# Upload a configuration file config.cfg to the TFTP server.
<Sysname> tftp 1.2.1.1 put config.cfg configback.cfg
# Specify newest.app as the main startup file to be used at the next startup.
z
Specify newest.app as the main startup file to be used at the next startup for the AMB.
<Sysname> boot-loader file newest.app slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 0!
z
Specify newest.app as the main startup file to be used at the next startup for the SMB (in slot 1).
<Sysname> boot-loader file slot1#flash:/newest.app slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!
# Reboot the device and the software is upgraded.
<Sysname> reboot
The startup file used for the next startup must be saved under the root directory of the storage medium.
You can copy or move a file to the root directory of the storage medium. For the details of the
boot-loader command, refer to Upgrading Software Commands in the Fundamentals Command
Reference.
TFTP Client Configuration Example (Distributed IRF Device)
Network requirements
z
As shown in
, Device is a IRF system, which is composed of a master and a slave. The
member ID of the master is 1, and the slot numbers of the AMB and the SMB on the master are 0
and 1 respectively. The member ID of the slave is 2, and the slot numbers of the AMB and SMB
on the slave are 0 and 1 respectively.