H3C Technologies H3C SR8800 User Manual
Page 100
89
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] mpls
[RouterA-GigabitEthernet3/1/1] mpls te
[RouterA-GigabitEthernet3/1/1] quit
# Configure Router B.
[RouterB] mpls lsr-id 2.2.2.2
[RouterB] mpls
[RouterB-mpls] mpls te
[RouterB-mpls] quit
[RouterB] interface GigabitEthernet 3/1/1
[RouterB-GigabitEthernet3/1/1] mpls
[RouterB-GigabitEthernet3/1/1] mpls te
[RouterB-GigabitEthernet3/1/1] quit
[RouterB] interface GigabitEthernet 3/1/2
[RouterB-GigabitEthernet3/1/2] mpls
[RouterB-GigabitEthernet3/1/2] mpls te
[RouterB-GigabitEthernet3/1/2] quit
# Configure Router C.
[RouterC] mpls lsr-id 3.3.3.3
[RouterC] mpls
[RouterC-mpls] mpls te
[RouterC-mpls] quit
[RouterC] interface GigabitEthernet 3/1/1
[RouterC-GigabitEthernet3/1/1] mpls
[RouterC-GigabitEthernet3/1/1] mpls te
[RouterC-GigabitEthernet3/1/1] quit
4.
Configure an MPLS TE tunnel
# Configure an MPLS TE tunnel on Router A.
[RouterA] interface tunnel 3
[RouterA-Tunnel3] ip address 6.1.1.1 255.255.255.0
[RouterA-Tunnel3] tunnel-protocol mpls te
[RouterA-Tunnel3] destination 3.3.3.3
[RouterA-Tunnel3] mpls te tunnel-id 10
[RouterA-Tunnel3] mpls te signal-protocol static
[RouterA-Tunnel3] mpls te commit
[RouterA-Tunnel3] quit
5.
Create a static CR-LSP
# Configure Router A as the ingress node of the static CR-LSP.
[RouterA] static-cr-lsp ingress tunnel3 destination 3.3.3.3 nexthop 2.1.1.2 out-label
20
# Configure Router B as the transit node on the static CR-LSP.
[RouterB] static-cr-lsp transit tunnel3 incoming-interface GigabitEthernet 3/1/1
in-label 20 nexthop 3.2.1.2 out-label 30
# Configure Router C as the egress node of the static CR-LSP.
[RouterC] static-cr-lsp egress tunnel3 incoming-interface GigabitEthernet 3/1/1
in-label 30
6.
Verify the configuration