H3C Technologies H3C SR8800 - Manual (Page 227)

216
[PE2-GigabitEthernet4/1/2] mpls ldp
[PE2-GigabitEthernet4/1/2] quit
# Configure OSPF on PE 2 for establishing LSPs.
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 192.3.3.3 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] network 10.2.2.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# On the interface connecting CE 2, namely GigabitEthernet 4/1/1, create a Martini MPLS
L2VPN connection. The interface requires no IP address.
[PE2] interface GigabitEthernet4/1/1
[PE2-GigabitEthernet4/1/1] mpls l2vc 192.2.2.2 101
[PE2-GigabitEthernet4/1/1] quit
5. Configure CE 2.
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface GigabitEthernet4/1/1
[CE2-GigabitEthernet4/1/1] ip address 100.1.1.2 24
6. Verify your configuration.
# Display L2VPN connection information on PE 1. The output shows that an L2VPN connection is
established.
[PE1] display mpls l2vc
Total ldp vc : 1 1 up 0 down 0 blocked
Transport Client VC Local Remote
VC ID Intf State VC Label VC Label
101 GE4/1/1 up 1024 1025
# Display the L2VPN connection information on PE 2. The output shows that an L2VPN connection
is established on PE 2.
[PE2] display mpls l2vc
Total ldp vc : 1 1 up 0 down 0 blocked
Transport Client VC Local Remote
VC ID Intf State VC Label VC Label
101 GE4/1/1 up 1025 1024
# Ping CE 2 from CE 1. The operation succeeds.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=30 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=50 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=40 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=70 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received