H3C Technologies H3C SR8800 - Manual (Page 210)

199
Step Command Remarks
4. Specify the tunneling
policy.
pw-tunnel-policy policy-name
Optional.
By default, the default tunneling
policy is used. The default
tunneling policy selects only one
tunnel (no load balancing) in this
order: LSP tunnel, CR-LSP tunnel.
5. Return to system view. quit N/A
6. Create the VLAN to be
used by the service
instance to match
packets.
vlan vlan-id N/A
7. Add the Layer 2 port
connecting the CE to the
VLAN.
port interface N/A
8. Return to system view. quit N/A
9. Configure an MPLS LDP
remote peer entity and
enter its view. mpls ldp remote-peer remote-peer-name N/A
10. Specify an IP address for
the remote peer.
remote-ip ip-address N/A
11. Enter the configuration
view of the Layer 2 port
that connects with the
CE.
interface interface-type interface-number N/A
12. Create a service
instance and enter
service instance view. service-instance instance-id
By default, no service instance is
created.
13. Specify a packet
matching VLAN ID for
the service instance.
encapsulation s-vid vlan-id
By default, no packet matching
VLAN ID is specified for the
service instance.
14. Create a Martini MPLS
L2VPN connection in the
service instance.
xconnect peer peer-ip-address pw-id pw-id
[ access-mode { ethernet | vlan } | mtu
mtu-value | [ pw-class class-name ] ] *
After this command is executed,
the VLAN ID, access mode, and
MTU configured for the service
instance cannot be changed. To
modify these parameters, you
must use the undo xconnect peer
command to remove the L2VPN
connection first.
NOTE:
•
You can configure up to 4094 service instances on a Layer 2 Ethernet port.
• The xconnect peer command is available for service instances with the ID in the range of 1 to 4094.
Configuring Kompella MPLS L2VPN
Kompella MPLS L2VPN uses extended BGP as the signaling protocol to transfer L2VPN information
between PEs.