H3C Technologies H3C SR8800 - Manual (Page 125)

114
[RouterA] interface tunnel 4
[RouterA-Tunnel4] ip address 8.1.1.1 255.255.255.0
[RouterA-Tunnel4] tunnel-protocol mpls te
[RouterA-Tunnel4] destination 4.4.4.9
[RouterA-Tunnel4] mpls te tunnel-id 10
[RouterA-Tunnel4] mpls te signal-protocol crldp
[RouterA-Tunnel4] mpls te commit
[RouterA-Tunnel4] quit
# Perform the display interface tunnel command on Router A. You can find that the tunnel interface
is up.
[RouterA] display interface tunnel
Tunnel4 current state: UP
Line protocol current state: UP
Description: Tunnel4 Interface
The Maximum Transmit Unit is 1500
Internet Address is 8.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
0 packets input, 0 bytes
0 input error
0 packets output, 0 bytes
0 output error
# Perform the display mpls te tunnel-interface command on Router A to view information about the
tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name : Tunnel4
Tunnel Desc : Tunnel4 Interface
Tunnel State Desc : CR-LSP is Up
Tunnel Attributes :
LSP ID : 1.1.1.9:2
Session ID : 10
Admin State : UP Oper State : UP
Ingress LSR ID : 1.1.1.9 Egress LSR ID: 4.4.4.9
Signaling Prot : CR LDP Resv Style : -
Class Type : CT0 Tunnel BW : 2000 kbps
Reserved BW : 2000 kbps
Setup Priority : 7 Hold Priority: 7
Affinity Prop/Mask : 0x0/0x0
Explicit Path Name : -
Tie-Breaking Policy : None
Metric Type : None
Record Route : Disabled Record Label : Disabled