H3C Technologies H3C SR8800 - Manual (Page 182)

171
[PE1-vsi-bbb] pwsignal bgp
[PE1-vsi-bbb-bgp] route-distinguisher 100:1
[PE1-vsi-bbb-bgp] vpn-target 111:1
[PE1-vsi-bbb-bgp] site 1 range 10
[PE1-vsi-bbb-bgp] quit
[PE1-vsi-bbb] quit
# Configure interface GigabitEthernet 3/1/2 and bind VPLS instance aaa or bbb to the interface.
[PE1] interface GigabitEthernet3/1/2
// To bind VPLS instance aaa to interface GigabitEthernet 3/1/2:
[PE1-GigabitEthernet3/1/2] l2 binding vsi aaa
// To bind VPLS instance bbb to interface GigabitEthernet 3/1/2:
[PE1-GigabitEthernet3/1/2] l2 binding vsi bbb
[PE1-GigabitEthernet3/1/2] quit
2. Configure PE 2.
# Configure the IGP protocol, such as OSPF. (Details not shown)
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname PE2
[PE2] interface loopback 0
[PE2-LoopBack0] ip address 2.2.2.9 32
[PE2-LoopBack0] quit
[PE2] mpls lsr-id 2.2.2.9
[PE2] mpls
[PE1-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
# Configure interface GigabitEthernet 3/1/1.
[PE2] interface GigabitEthernet 3/1/1
[PE2-GigabitEthernet3/1/1] ip address 10.10.10.11 24
# Configure basic MPLS on the interface.
[PE2-GigabitEthernet3/1/1] mpls
[PE2-GigabitEthernet3/1/1] mpls ldp
[PE2-GigabitEthernet3/1/1] quit
# Configure the remote LDP session.
[PE2] mpls ldp remote-peer 2
[PE2-mpls-remote-2] remote-ip 1.1.1.9
[PE2-mpls-remote-2] quit
# Configure BGP extensions.
[PE2] bgp 100
[PE2-bgp] peer 1.1.1.9 as-number 100
[PE2-bgp] peer 1.1.1.9 connect-interface loopback 0
[PE2-bgp] vpls-family
[PE2-bgp-af-vpls] peer 1.1.1.9 enable
[PE2-bgp-af-vpls] quit
[PE2-bgp] quit
# Enable L2VPN and MPLS L2VPN.