H3C Technologies H3C SR8800 - Manual (Page 225)

214
# Enable L2VPN and MPLS L2VPN.
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
# Enable LDP globally.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure the peer relationship with PE 2 so that the LDP remote session can be established
between them.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 192.3.3.3
[PE1-mpls-ldp-remote-1] quit
# Configure the interface connected with the P router, namely GigabitEthernet 4/1/2, and enable
LDP on the interface.
[PE1] interface GigabitEthernet4/1/2
[PE1-GigabitEthernet4/1/2] ip address 10.1.1.1 24
[PE1-GigabitEthernet4/1/2] mpls
[PE1-GigabitEthernet4/1/2] mpls ldp
[PE1-GigabitEthernet4/1/2] quit
# Configure OSPF on PE 1 for establishing LSPs.
[PE1] ospf
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] network 10.1.1.1 0.0.0.255
[PE1-ospf-1-area-0.0.0.0] network 192.2.2.2 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# On the interface connecting CE 1, namely GigabitEthernet 4/1/1, create a Martini MPLS
L2VPN connection. The interface requires no IP address.
[PE1] interface GigabitEthernet4/1/1
[PE1-GigabitEthernet4/1/1] mpls l2vc 192.3.3.3 101
[PE1-GigabitEthernet4/1/1] quit
3. Configure the P router.
# Configure the LSR ID and enable MPLS globally.
<Sysname> system-view
[Sysname] sysname P
[P] interface loopback 0
[P-LoopBack0] ip address 192.4.4.4 32
[P-LoopBack0] quit
[P] mpls lsr-id 192.4.4.4
[P] mpls
# Enable LDP globally.
[P] mpls ldp
[P-mpls-ldp] quit
# Configure the interface connected with PE 1, namely GigabitEthernet 4/1/1, and enable LDP
on the interface.
[P] interface GigabitEthernet4/1/1
[P-GigabitEthernet4/1/1] ip address 10.1.1.2 24