Configuring secpath – H3C Technologies H3C SecPath F1000-E User Manual
Page 189
179
Figure 146 Adding an account for device management
Configuring SecPath
# Configure the IP address and security zone of each interface. (Details not shown.)
# Configure the RADIUS scheme system:
1.
Select User > RADIUS from the navigation tree and then click Add in the RADIUS scheme list area.
2.
Configure basic information for the RADIUS scheme:
{
Enter system as the scheme name.
{
Select Extended as the server type.
{
Select With domain name for the username format.
3.
In the RADIUS Server Configuration area, click Add to configure a RADIUS authentication server
for the scheme as follows:
{
Select Primary Authentication as the server type.
{
Enter 10.1.1.1 as the IP address of the primary authentication server.
{
Enter 1812 as the port.
{
Set the key to expert and confirm the key.
4.
Click Apply.