H3C Technologies H3C SecPath F1000-E - Manual (Page 213)

203
Step Command Remarks
2. Enter HWTACACS
scheme view.
hwtacacs scheme hwtacacs-scheme-name N/A
3. Specify HWTACACS
authentication servers.
• Specify the primary HWTACACS
authentication server:
primary authentication ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
• Specify the secondary HWTACACS
authentication server:
secondary authentication ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
Configure at least one command.
No authentication server is
specified by default.
Specifying the HWTACACS authorization servers
You can specify one primary authorization server and up to one secondary authorization server for an
HWTACACS scheme so that the NAS can find a server for user authorization when using the scheme.
When the primary server is not available, the secondary server is used. In a scenario where redundancy
is not required, specify only the primary server.
Follow these guidelines when you configure HWTACACS authorization servers:
• An HWTACACS server can function as the primary authorization server of one scheme and
simultaneously as the secondary authorization server of another scheme.
• The IP addresses of the primary and secondary authorization servers cannot be the same.
Otherwise, the configuration fails.
• You can remove an authorization server only when no active TCP connection for sending
authorization packets is using it.
To specify HWTACACS authorization servers for an HWTACACS scheme:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter HWTACACS scheme
view.
hwtacacs scheme hwtacacs-scheme-name N/A
3. Specify HWTACACS
authorization servers.
• Specify the primary HWTACACS
authorization server:
primary authorization ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
• Specify the secondary HWTACACS
authorization server:
secondary authorization ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
Configure at least one
command.
No authorization server is
specified by default.
Specifying the HWTACACS accounting servers and the relevant parameters
You can specify one primary accounting server and up to one secondary accounting server for an
HWTACACS scheme so that the NAS can find a server for user accounting when using the scheme.
When the primary server is not available, the secondary server is used. In a scenario where redundancy
is not required, specify only the primary server.