H3C Technologies H3C SecPath F1000-E - Manual (Page 215)

205
Step Command Remarks
3. Specify the shared keys for
authenticating HWTACACS
authentication, authorization,
and accounting packets.
key { accounting | authentication |
authorization } [ cipher | simple ]
key
No shared key is specified by
default.
In FIPS mode, the firewall supports
only ciphertext shared keys of at
least 8 characters comprising
case-sensitive letters, numbers, and
special characters.
NOTE:
A shared key configured on the firewall must be the same as that configured on the HWTACACS server.
Specifying a VPN for the HWTACACS scheme
After you specify a VPN for an HWTACACS scheme, all the authentication, authorization, and
accounting servers specified for the scheme belong to the VPN. However, if you also specify a VPN when
specifying a server for the scheme, the server belongs to the specific VPN.
To specify a VPN for an HWTACACS scheme:
Step Command
1. Enter system view. system-view
2. Enter HWTACACS scheme view. hwtacacs scheme hwtacacs-scheme-name
3. Specify a VPN for the HWTACACS scheme. vpn-instance vpn-instance-name
Setting the username format and traffic statistics units
A username is usually in the format of userid@isp-name, where isp-name represents the name of the ISP
domain to which the user belongs and is used by the firewall to determine which users belong to which
ISP domains. However, some HWTACACS servers cannot recognize usernames that contain an ISP
domain name. In this case, the firewall must remove the domain name of each username before sending
the username. You can set the username format on the firewall for this purpose.
The firewall periodically sends accounting updates to HWTACACS accounting servers to report the
traffic statistics of online users. For normal and accurate traffic statistics, make sure the unit for data flows
and that for packets on the firewall are consistent with those configured on the HWTACACS servers.
Follow these guidelines when you set the username format and the traffic statistics units for an
HWTACACS scheme:
• If an HWTACACS server does not support a username with the domain name, configure the firewall
to remove the domain name before sending the username to the server.
• For level switching authentication, the user-name-format keep-original and user-name-format
without-domain commands produce the same results. They make sure usernames sent to the
HWTACACS server carry no ISP domain name.
To set the username format and the traffic statistics units for an HWTACACS scheme:
Step Command Remarks
1. Enter system view. system-view N/A