Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer - Manual (Page 14)

14 The T-1 Notebook : Reference & Guide
NOTES
6 Steps To Creating A Drum Beat.
The objective is to create a simple kick, snare, hat drum loop. The sounds
will be handled by a desktop drum synth, in this case Elektron’s Digitakt but
could equally be another device or DAW. The synth is connected by MIDI.
Step 1. Connect the Gear.
MIDI Out
Using the 5 Pin to
3.5mm adapter
MIDI Config
The destination device must be configured to receive MIDI. Clock can be external from T-1 but
Transport should be off, so that only T-1 controls the sequence. Device tracks and associated MIDI
Channels should match with the sound required.
Track, Channels:-
Track 1, Channel 1 = Kick
Track 2, Channel 2 = Snare
Track 3, Channel 3 = HiHat
Track 4, Channel 4 = Bass
Track / Channels:-
Track 1, Channel 1 = Kick
Track 2, Channel 2 = Snare
Track 3, Channel 3 = HiHat
Track 4, Channel 4 = Bass
MIDI In
Connected to sound
module
Audio Out
Connected from sound module to
mixer, speakers or headphones.
Getting Started
1