Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer - Manual (Page 8)

8 The T-1 Notebook : Reference & Guide
1.3 Power Up
T-1 Sequencer is powered using the USB-C connection located at the rear
of the unit. There is no power switch and T-1 will power on immediately
when power is applied. T-1 requires a minimum of 390mA with 100%
brightness but will operate from 200mA upwards. The T-1 Default
brightness setting is 75% which is adjustable. A 500mA minimum power
source is recommended.
▌ POWERING ON / OFF THE T-1 SEQUENCER
1. Connect the supplied USB-C cable between T-1 Sequencer and a USB
supply. This could be:-
• A portable USB power bank.
• USB Mains supply adapter.
• A powered USB hub.
• A PC or Macbook.
• A tablet or mobile device.
• Another powered device such as an instrument or synth.
2. T-1 will start up and the pads will illuminate ORANGE ⬛ .
3. To power the unit off, disconnect the USB-C cable or the supply.
NOTES
USB
USB
PC / Mac
T-1
USB Main Adapter
USB Power Bank
Getting Started
1