Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer - Manual (Page 20)

20 The T-1 Notebook : Reference & Guide
NOTES
7 Steps To Creating A Melody.
Objective. The objective is to build on the drum beat project and add more
melodic elements. Also to include additional hardware in the process as a
sound source. The melodic sounds will be handled by a desktop FM synth,
in this case Elektron’s Digitone but could equally be another device or DAW.
Step 1. Connect the Gear.
MIDI Out
Using the 5 Pin to
3.5mm adapter
MIDI Config
The destination device must be configured to receive MIDI. The MIDI IN and Thru connections are used
to ensure a single MIDI network with two devices controlled by T-1. Clock can be external from T-1 but
Transport should be off, so that only T-1 controls the sequence. Device tracks and associated MIDI
Channels should match with the sound required.
Audio Config
Both sound modules can be connected to a mixer and in turn to monitors or headphones.
Track, Channels:-
Track 1, Channel 1 = Kick
Track 2, Channel 2 = Snare
Track 3, Channel 3 = HiHat
Track 4, Channel 4 = Bass
Track 5, Channel 5 = Lead
Track 6, Channel 6 = Lead
Track 7, Channel 7 = Lead
Track 8, Channel 4 = CC Ctrl
Track / Channels:-
Track 1, Channel 1 = Kick
Track 2, Channel 2 = Snare
Track 3, Channel 3 = HiHat
Track 4, Channel 4 = Bass
Track 5, Channel 5 = Lead
Track 6, Channel 6 = Lead
Track 7, Channel 7 = Lead
Track 8, Channel 4 = CC Ctrl
MIDI In
Connected to drum
sound module
MIDI In
Connected from drum
sound module
MIDI Thru
Connected from drum
to synth module
Getting Started
1