Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer - Manual (Page 26)

26 The T-1 Notebook : Reference & Guide
NOTES
Step 6. Control Change Messages
T-1 Can also perform control changes to external parameters on
compatible devices. These CC messages are set on a T-1 CC Track as
opposed to a normal note track. This example controls the filter cutoff for
the bass sound in the Digitakt.
▌ CONTROLLING AN EXTERNAL SYNTH PARAMETER
1. Select a new CC track, Press [CTRL] + [VB9] for Track 9. This will be lit
CYAN ⬛ . The commands cycle between track modes.
2. Set the channel for the Bass sound by holding and turning (CHANNEL).
This should be channel 4, i.e. value button 4 lit.
3. Digitakt filter cutoff is CC#74. Check the actual device you use for the
MIDI Mappings to determine the representation for the specific device.
4. By default, the (VELOCITY) knob represents CC#74. When on Track 9
this parameter can be changed which will transmit the value change to
the destination device.
5. When playing the song arrangement the (VELOCITY) knob will change
the bass filter cutoff value. This example is based on a manual control
action to change the parameter.
Getting Started
1