Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer - Manual (Page 168)

168 The T-1 Notebook : Reference & Guide
NOTES
▌ MANUALLY CONTROLLING EXTERNAL GEAR CC FROM T-1
1. Ensure the T-1 and the target device are connected by MIDI USB or 5
Pin DIN. Parameters to enable T-1 to communicate to the device such
as Channel must be set. Some devices need to be set to receive CC.
2. Press [BANK] to ensure the ‘home’ track view is in focus.
3. Select a track in CC mode. Hold [CTRL] + [VBx] where ‘x’ is the value
button for the track to select. CC Tracks will illuminate CYAN ⬛ . Notes
tracks will illuminate ORANGE ⬛ and FX Tracks MAGENTA ⬛ .
4. The 14 rotary knobs in the Shape, Groove and Tonal section will be
preassigned to CC numbers, 70-76 Top row and 77-83 bottom row.
5. The mapping of the external device parameters is usually documented
in the manual. This is called the ‘MIDI Implementation’ of a device. In
this example, assume destination CC74 is Filter Cutoff.
6. To adjust the CC with T-1’s default CC assigned;
• Relative adjustment. Turn (VELOCITY) control knob will affect CC74
and therefore will manually adjust cutoff on the destination device.
This is a relative change and can adjust up or down from the current
parameter value.
• Absolute adjustment. Hold (VELOCITY) + Press [VBx], where ‘x’ is a
value button that represents an absolute value in the 1-127 range to
send to the destination device.
Turn (VELOCITY)
Relative Value Adjustment
Press (Knob) + [VBx]
Absolute Value Setting
Example
CC #74
96
64 65
+
63
-
Example Filter Cutoff
Sweep
Step
MIDI & WiFi Connectivity
8