FANUC Robotics America GFK-1541B - Manual (Page 14)

GFK-1541B 2-1
Installation
This chapter contains installation instructions for each Series 90 module that includes an Ethernet
Interface.
ƒ Section 1: IC693CMM321 Series 90-30 TCP/IP Ethernet Interface (10Base-T type)
ƒ Section 2: IC693CPU364 Series 90-30 CPU with Embedded TCP/IP Ethernet Interface
ƒ Section 3: IC693CPU374 Series 90-30 CPU with Embedded TCP/IP Ethernet Interface
ƒ Section 4: IC697CMM742 Series 90-70 TCP/IP Ethernet Interface
Each section covers the basic features of the Ethernet Interface, its installation, configuration, and
a procedure for its initial checkout on your Ethernet cable. Each section first provides a hardware
overview of the Ethernet Interface and is then divided into four Installation Procedures, each
providing an overview of the procedure and then explaining the detailed steps to be performed.
The installation procedures described for each Ethernet Interface are:
ƒ Installing the Ethernet Interface in the PLC - Required
ƒ Configuring the Ethernet Interface - Required
ƒ Verifying Proper Power-Up of the Ethernet Interface - Required
ƒ “Pinging” the Ethernet Interfaces on the Network - Optional
Some of the procedures require prior Ethernet cable plant design and installation.
2
Chapter
www.cadfamily.com EMail:[email protected]
The document is for study only,if tort to your rights,please inform us,we will delete