FANUC Robotics America GFK-1541B User Manual
Page 38
2-25
2
Serial Port Parameters
These parameters are for the RS-232, RJ-11 serial port on the CPU364 module. This port is used
for both the Station Manager connection and for connecting to the Software Loader. The
Software Loader settings take effect automatically when the Ethernet Interface enters the
“Software Load” state. For all other states the Station Manager settings take effect. Refer to
“Verifying Proper Power-Up of the Ethernet Interface”, for more information on states of the
Ethernet Interface.
Data Rate (bps):
Data rate (bits per second) for the port. Choices are 300, 600, 1200, 2400,
4800, 9600‡, or 19200*.
Parity:
Type of parity to be used for the port. Choices are None‡, Even, or Odd*.
Stop Bits:
Enter the number of stop bits. Choices are 1*‡ or 2.
Flow Control:
Type of flow control to be used for the port. Choices are Hardware, Software, or
None*‡. The Software selection has no effect.
Modem TT (Turnaround Delay):
Turnaround delay time to be used for the port. The value
entered is the number of 10 ms increments for the Turnaround delay. Choices are 0*‡-255. (e.g.
a value of 100 will provide a 1000 ms, or 1 second, Turnaround delay)
Timeout:
This parameter is currently not used by the Ethernet Interface. Changing this
parameter has no effect.
* Default selection for the Software Loader Port.
‡ Default selection for the Station Manager Port.
The document is for study only,if tort to your rights,please inform us,we will delete