Power requirement, Led indicator light – FANUC Robotics America GFK-1541B User Manual
Page 218
ristics
B-17
B
IC649AEA103 Ethernet 10Base2 Transceiver
Note: This transceiver replaces catalog number IC649AEA101
• Compliant with the IEEE 802.3 Ethernet specification for 10Base2.
• A standard BNC connector is mounted on the body of the transceiver for connection to thin
coaxial Ethernet cable
• This unit has an attached 10” (254 mm) cable with standard 14–pin AAUI connector for
connecting to a Series 90–30 Ethernet module (IC693CMM321) or CPU with Ethernet
interface (IC693CPU364).
• SQE slide switch is set to enabled position at the factory. It must be in this position for
proper operation with GE Fanuc Ethernet products IC693CMM321 and IC693CPU364 (see
figure below).
• Power LED indicator light.
10 inches (254mm)
14-Pin AAUI
Connector
8 9 101112 13 14
7 6 5 4 3 2 1
3.2 inches (81 mm)
2 inches
(51 mm)
Green LED
Power
SQE Slide Switch (recessed in
Slide Switch in this Direction to Enable
0.9"
(23 mm)
BNC Connector
Power Requirement
This unit draws 400 mA @ 5Vdc from the Ethernet Interface via the AAUI connector.
LED Indicator Light
Located on the side of the unit as shown above. This green LED turns on to indicate the presence
of 5Vdc power to the unit.
The document is for study only,if tort to your rights,please inform us,we will delete